an5465s003010e

Retrofit reversing camera wiring harness in liftgate

Typ an · temat 54.65 · wersja 0200 · 2019-01-02

Dotyczy: Model 447.8 with code W68 (Electrically operated liftgate) Model 447 with code W65 (Tailgate)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 54 Instalacja elektryczna, wyposażenie i wskaźniki › 54.65 Wspomaganie parkowania — Seria 447

EinPAS 36 Widoczność › 36.25 System kamery › 36.25.3 Pofabryczny montaż/przebudowa — Seria 447

AN54.65-S-0030-10E

Retrofit reversing camera wiring harness in liftgate

Model

447.8

with code W68 (Electrically operated liftgate)

Model

447

with code W65 (Tailgate)

Modification notes

18.12.2018

Method extended

Operation steps 1, 2, 5,

Retrofit reversing camera wiring harness in liftgate

115 589 03 59 00

Long wedge

Retrofit reversing camera wiring harness in liftgate

1

Remove plug housing at power supply plug of vehicle interior (7).



2

Remove cable duct (11) at electrical wiring harness of liftgate (1).


The cable duct (11) is no longer required.


1

Liftgate electrical wiring harness

2

Camera contact socket

3

Camera power supply connector

4

Door handle power supply connector

5

Camera cover control unit connector

6

Camera contact socket

7

Vehicle interior power supply connector

8

Door handle power supply connector

11

Cable duct

S54.65-A003-11

Retrofit reversing camera wiring harness in liftgate

S54.65-A004-09

Shown on model 447.8 with code W68 (Electrically actuated liftgate)

3

Loosen cable duct (9) at rear roof frame and liftgate with long wedge.

4

Route electrical wiring harness of liftgate (1), as shown, in liftgate through cable duct (9) and up to right D-pillar.

Do not kink the liftgate electrical wiring harness (1) and ensure that it is routed without chafing.
This prevents damage.

Model 447.7 with code V23 (Interior trim, superior version) Model 447.8
To do so, pull the headliner (10) down carefully in the routing area.

5

Reinstall plug housing at power supply plug of vehicle interior (7).

6

Attach supplied plug housing to control unit plug of camera cover (5).

7

Secure liftgate electrical wiring harness (1) section by section to factory-installed electrical wiring harness using cable ties.

The camera contact socket (2), the power supply plug of the camera (3) and the power supply plug of the door handle (4, 8) are only installed when the door handle is installed.
The camera cover control unit plug (5) is only attached when the camera cover (KAB) control unit (N144) is installed.
The camera contact socket (6) and the power supply plug of the vehicle interior (7) are only installed after the vehicle interior electrical wiring harness has been routed.

8

Attach cable duct (9) to rear roof frame and liftgate.