AR27.60-S-0100A | Remove, install automatic transmission cable | 29.11.95 |
MODEL 638 with ENGINES 111, 601.970, 611.980, 104.900 with CODE (G40) Automatic transmission
S27.60-2002-09
Shown on transmission 503.020/01/02/03
1 Selector lever
2 Relay lever
3 Shift cable
4 Retainer
5 Rubber grommet
6 Accelerator pedal
7 Instrument panel
8 Air duct
| Remove/install | ||
1.1 | Remove air duct connecting piece. | Only model 638.0/1 without code H00 (hot air duct to passenger compartment) | |
1.2 | Remove air duct (8) for rear passenger compartment. | Do not remove air duct completely (8). Refer to: | |
Model 638.0/1 with Code H00 (hot air duct to passenger compartment) and left-hand drive. | |||
Model 638.2 and left-hand drive. | |||
Model 638.0/1 with Code H00 (hot air duct to passenger compartment) and right-hand drive. | |||
Model 638.2 and right-hand drive | |||
2 | Remove ashtray | ||
3 | Detach cable (3) at transmission. | ||
4 | Detach cable (3) at relay lever (2). | Set selector lever (1) to position "1". | |
5 | Remove retainer (4). | Installation: inspect retainer (4), replace if necessary. | |
6 | Press grommet (5) out of mounting bore. | Installation: ensure that grommet (5) is seated properly at firewall. | |
7 | Remove cable (3) together with grommet (5) forwards through firewall towards engine compartment. | ||
8 | Install in the reverse order | ||
| Testing | ||
9 | Check adjustment of cable (3), and adjust cable (3) if necessary. | Model 638 up to VIN 400544 | |
Model 638 up to VIN 400545 |