AR83.70-D-5685A | Remove/install overheating sensor | 8.9.97 |
MODELS 901.32#, 902.32# /42#, 903.32# /42#, 904.32# /42# ## as of 753731 as of 3.11.97 with CODE (H11) Warm air auxiliary heater
D1L-C compact heater
MODELS 901.62#, 902.62#, 903.62#, 904.62#, 905.62# ## up to 382001 up to 11.3.02 with CODE (H11) Warm air auxiliary heater
D1L-C compact heater
D83.70-1300-09
1 Gasket
2 Cover
3 Bolt
4 Body-bound rivet
5 Upper casing half
11 Overheating sensor plug
12 Overheating sensor
13 Fuse
14 Outlet shroud
6 Glow plug
7 Lower casing half
8 Air intake grill
9 Auxiliary heating control unit
10 14-pin plug
| Remove/Install | ||
1 | Remove heater | ||
2 | Unscrew bolt (3) and remove cover (2) with gasket (1) | Installation: Check gasket (1) for damage and replace if necessary. | |
3 | Unlock 14-pin plug (10) and disconnect from auxiliary heater control unit (9) | ||
4 | Detach connection lines from the glow plug (6) | ||
5 | Detach air outlet (14) from casing housing | ||
6 | Unlock and remove air intake grill (8) | ||
7 | Detach upper casing half (5) from lower casing half (7). | Drive through drift of body-bound rivets (4) using a suitable tool and lever out rivet using the blade of a knife. | |
8 | Disconnect plug (11) of overheating sensor (12) from auxiliary heater control unit (9) | Installation: Observe accurate cable routing. | |
9 | Remove fuses (13) from overheating sensor (12) | Using a suitable tool, press fuses (13) apart and detach Installation: Replace fuses. Grasp the fuses using two suitable tools and push on with the hole downwards until they abut axially (arrow). | |
10 | Remove overheating sensor (12) | ||
11 | Install in the reverse order |