W07.15-0079-09
A, B, C, D Display in HHT
E Display in FDOK
1 | Connect hand-held tester (HHT) to vehicle | Hand-Held-Tester (HHT) | |
Test cable (multiplexer) | |||
Adapter cable for diagnostic socket 14-pole | |||
HHT operating instructions | |||
Case | |||
Commercial vehicle test module | |||
2 | Switch on ignition | ||
3 | Call MR (PLD) system with HHT | In order to "program keys", the shop must have FDOK access authorization. | |
4 | Call menu "program key" | Display (A) appears on the HHT. Select menu 1, if – the MR (PLD) control module or engine has been replaced – an additional new key is required for the vehicle. Select menu 2, if – one or more keys have been lost and are to be desynchronized. | |
5 | Select menu 1 or 2 | Display (B) appears on the HHT. | |
6 | Note all values on display (B) | These values are required for entry in FDOK. | |
7 | Select display 10 "commercial vehicle" in FDOK | ||
8 | Select display 1801 "programming immobilizer keys" | ||
9 | Enter vehicle ident. no. in display (E) | The remaining vehicle data is entered automatically in the display headline by FDOK | |
10 | Enter values taken from HHT in FDOK display (E). | ||
11 | Enter number of ordering workshop in FDOK display (E) and confirm with enter key (release data) | The coded random access number is calculated and indicated on the display. | |
12 | Switch HHT over to next display (D) with enter key | ||
13 | Enter coded random access number from FDOK and confirm with enter key | If display (C) appears on the HHT, the coded random access number has been recognized as correct and the first transponder key is programmed. | |
- Repeat steps 3 through 13 for each additional transponder key to be programmed. If a number of keys are programmed, wait until the control module has completed the operation (requires approx. 2 minutes), before attempting to program the next key. If the next key is programmed before expiration of this time the HHT indicates "key already programmed". | |||
- In this phase the vehicle can also be started with the key not yet programmed. However, after switching off the ignition it is no longer possible to start the vehicle with this key. In such cases it is therefore necessary to program the key again. |
Commercially available tools
Number | Designation | |
WH58.30-Z-1036-13A | Handheld tester (HHT) | 651 100 01 99 |
WH58.30-Z-1037-13A | Test cable (multiplexer) | 651 100 40 99 |
WH58.30-Z-1039-13A | Adapter cable for 14-pin diagnostic socket | 651 101 40 99 |
WH58.30-Z-1040-13A | HHT operating instructions | 651 100 21 00 |
WH58.30-Z-1041-13A | Case | 651 101 60 99 |
WH58.30-Z-1042-13A | Commercial vehicle test module | 651 156 00 00 |