Removing and installing rubber mount on wishbone

Type ar · thema 33.20 · versie 0107 · 2001-08-09

Geldig voor: MODEL 901, 902 with FRONT AXLE 730.408 /410 MODEL 902, 903 with FRONT AXLE 730.409 MODEL 903 with FRONT AXLE 730.413 MODEL 904 with FRONT AXLE 730.411 /414 MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG1) Engageable all-wheel drive MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG2) Permanent all-wheel drive MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG3) Reduction ratio for all-wheel drive MODEL 905 with FRONT AXLE 730.606 MODEL 690.6 with FRONT AXLE 732.2

Niet beschikbaar in “nl”; getoond in Engels.

Plaats

Functiegroep 2 Onderstel › 33 Vooras › 33.20 Wielophanging, naaf — Serie 690 (modellen 6**) · Serie 901 · Serie 902 · Serie 903 · Serie 904 · Serie 905

EinPAS 17 Aandrijflijn/as › 17.50 Vooras › 17.50.41 Dwarsgeplaatste wieldraagarm/geleidearm/stabilisator — Serie 690 (modellen 6**) · Serie 901 · Serie 902 · Serie 903 · Serie 904 · Serie 905

Geldt ook voor motoren/versnellingsbakken: 730 408, 730 409, 730 410, 730 411, 730 413, 730 414, 730 606, 732 2**

AR33.20-D-1452-01A

Removing and installing rubber mount on wishbone

730 589 00 43 00

Press-in/out tool

D33.20-0001-11

1 Wishbone

2 Rubber mount

D33.20-0023-01

Removing

1 Fit wishbone (1) with drift (01) on the  remover (03) and press out rubber mount.

D33.20-0024-01

Installing

2 Coat new rubber mount with oil.

3 Place  in the press in the sequence illustrated with the wishbone and rubber mount.

4 Press rubber mount into wishbone as far as the stop on the drift.

D33.20-0026-01

D33.20-0025-01

5 Insert drift  into rubber mount from below.

6 Place counterholder  on rubber mount and press back rubber mount until it is seated in the center of the wishbone.

D33.20-0027-01

 If the rubber mount is pressed too far through, turn  over and press rubber mount back to the correct position.