P13.22-2107-12
1 Poly-V-belt
2 Tensioning pulley
3 hexagon
| Removing | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | |
1 | Open engine hood and raise to vertical position | ||
2 | Loosen poly-V-belt (1) and remove | by turning hexagon (3) on the tensioning pulley (2) anti-clockwise and locking the tensioning pulley (2) with a drift (diameter 5 mm). | |
| Checking | ||
3 | Inspect belt pulley sections and tensioning device | Check for damage, wear and dirt; replace if necessary. | |
4 | Check guide pulley | Replace if necessary. | |
| |||
5 | Check poly-V-belt (1) | ||
| Check poly-V-belt in visible area for wear | ||
| Install | ||
6 | Install poly-V-belt (1) and tighten it. | Do not use belt wax or any similar products. Start in numerical order of the relevant running diagram at tensioning pulley (2), refer to: | |
Layout diagram of poly-V-belt | |||
7 | Close engine hood |
Coolant pump, coolant thermostat
Verwezen documenten
- ap1322p1352rt V-riem bij zichtbare deel op slijtage controleren
- ap1322p1352rtc V-riem bij zichtbare deel op slijtage controleren
- ap1322p1352rtd V-riem bij zichtbare deel op slijtage controleren
- ar1322p390202gz
- ar8840p1000rt
- as0000z001101a Kans op letsel door afklemmen of bekneld raken van vingers bij het uit-, inbouwen en bij afstelwerkzaamheden aan deksels, portieren, kleppen en schuifdak.