W26.30-1019-06
Modified version
1 Sealing
2 Oil pump drive shaft
3 Snap ring
4 Ball bearing
5 Closing cover
Along the technical evolution, the closing cover (5) was modified. Through this, the sealing gasket (1) is eliminated. The oil pump closing cover was integrated in the closing cover (5). The sealing of the closing cover (5) occurs through sealing compound. The bearing of the oil pump (2) rive shaft was equally modified, i.e. the ball bearing (4) is now seated inside the drive shaft of the oil pump (2) and the snap-ring (3) is seated in the groove on the gear of the oil pump (2) drive shaft.
When a PTO is retrofitted, it is necessary to observe that the oil pump cover is also installed and that a new compensation washer has to be determined for the oil pump.