AR98.00-P-0201A | Covering when painting roof with sliding roof or roof rails | 16.10.08 |
MODEL 124.18 /19 /39 /07 /08 /09 /29, 126, 202.07 /08 /18, 210.2
P65.00-0308-01
1 Cover
2 Windshield
3 Engine hood
P98.00-0203-01
Modification notes
| Removing | ||
| Notes on paintwork repairs | ||
| General notes about painting the body flange in the glazing area | Pay attention to notes concerning the preparation of new parts such as the A-pillar, the roof or the side walls. | |
1 | Remove sliding roof cover and side seal at roof cut-out | In vehicles with sliding roof | |
2 | Remove roof railing | In vehicles with roof railing | |
Mask | |||
3 | Mask off rubber seal at front roof and at rear sliding roof with adhesive tape | In vehicles with sliding roof | |
4 | Mask off sliding roof frame in vicinity of side seal | In vehicles with sliding roof | |
With 50 mm wide adhesive tape. | |||
5 | Replace luggage rails on roof | Only with models 202 and 210 with luggage rails on roof. | |
6 | Mask fresh air aperture between windshield (2) and engine hood (3) with covering material (1) | Only on model 126 | |
7 | Mask entire vehicle with masking paper |
참조 문서
- ah9800p940802a 도장 정비 지침
- ah9800p940806a 유리가 장착된 영역의 바디 플랜지 도장 관련 일반 지침