ar8840s3151p

Remove/install engine hood cable

유형 ar · 주제 88.40 · 버전 0100 · 2017-11-02

적용 대상: Model 470, 471

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 3 구조 › 88 부착부품, 외측　플랩 › 88.40 엔진후드, 프런트플랩 — 시리즈 470 · 시리즈 471

EinPAS 29 주행 인증/안전 시스템 › 29.16 잠금/해제 › 29.16.32 잠금/작동 — 시리즈 470 · 시리즈 471

AR88.40-S-3151P

Remove/install engine hood cable

12.05.2017

Model

470, 471

Remove/install engine hood cable

S88.40-4559-09

1

Engine hood cable

3

Firewall

2

Rubber grommet

4

Retaining clips

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Remove left front headlamp unit

AR82.10-S-4733P

2

Unclip retaining clips (4)

Installation: Replace the retaining clips (4).

3

Unhook engine hood control cable (1) from engine hood lock

AR88.40-S-3201P

4

Pull out hood cable (1) on footwell side through firewall (3)

Removal: Mark installation position of hood cable (1) at suitable points in engine compartment, e.g. at bracket for hood cable (1).

Installation: Install rubber grommet (2) in firewall (3).

Installation: Observe installation position of rubber grommet (2) and hood cable (1).

5

Remove hood cable (1) with handle

When replacing hood cable (1).

AR88.40-S-3150P

6

Install in the reverse order

Check

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

7

Lock engine hood, unlock and lock again

To check hood cable (1) for proper function.

참조 문서