AR83.70-P-5700FAA | Remove/install coolant circulation pump | 7.9.10 |
MODELS 170.444 /449 1# with TRANSMISSION 722.6
Retrofitted Thermo Top C stationary heater
P83.70-3899-06
3 Coolant return hose, heater
4 Coolant feed hose, heater
5 Heater cover
8 Circulation pump coupling
13 Circulation pump bracket
17 Circulation pump attachment
A6 Heater, stationary heater
A6m1 Circulating pump
| Removing, installing | ||
Danger! | Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage bottles. Wear protective gloves, protective clothing and eye protection. | |
1 | Reduce pressure in coolant circuit | To do this, turn closure cap of coolant expansion tank to notch position 1. | |
2 | Remove and disassemble heater (A6) | Only disassemble until circulation pump (A6m1) can be removed. | |
3 | Unclip heater cover (5) | ||
4 | Disconnect circulation pump coupling (8) | Installation: coupling is coded. | |
5 | Release circulation pump attachment (17) and detach bracket (13) | Installation: attach circulation pump bracket first. | |
6 | Detach circulation pump (A6m1) from coolant hose (4) | Collect escaping coolant and fill back into coolant expansion tank after installation. | |
7 | Install in the reverse order | ||
8 | Bleed coolant circuit following installation of the heater | ||
Checking | |||
Danger! | Risk of explosion due to fuel vapors, risk of poisoning from breathing in combustion gases and risk of injury due to combustions during or after heating operation | Do not operate stationary heater, auxiliary heater or engine with heater booster in closed areas or when refueling. Allow heater unit to cool down after operation and wear protective gloves. | |
7 | Start up stationary heater | ||
| Start up stationary heater | If the heater (A6) switches off automatically before reaching its operating temperature and if it cannot be restarted, there is a fault interlock: | |
Cancel fault interlock | |||
10 | Check cooling system for leaks |
Stationary heater
참조 문서
- ar2000p1010p 냉각시스템의 기밀성을 점검하십시오.
- ar8370p530201e 히터를 장착한 후 냉매회로를 배기하십시오.
- ar8370p530207ca
- ar8370p5302nc
- ar8370p5302nc 히터 탈, 장착
- as2000z000101a 뜨거운 냉각수 분출 시 입은 화상에 의한 피부와 안구의 상해 위험 냉각수의 음용으로 인한 중독 위험
- as8370z000201a 연료 증발가스에 의한 폭발 위험, 연소가스 흡입으로 인한 중독 위험 및 히터 작동 시 또는 작동 후 화상 위험
- az8370p000804a 독립식 히터 작동