P83.25-0209-06
Illustrated on model 202
4 Water collector
5 Rubber wiper mount
8 Water drain
10 Wiring duct
P83.25-0384-06
Illustrated on model 202
4 Water collector
7 Clips for air intake
9 Water drain
15 Control module box
16 Screws
X11/4 Data link connector
P83.25-0385-06
Illustrated on model 202
11 Firewall center section
12 Clamp
13 Screw
14 Clip
| Removal, installation | ||
1 | Remove cover on left and right air intake | ||
2 | Remove wiper system | ||
3 | Unscrew rubber mounts (5) | ||
4 | Unscrew plastic nuts on outside of left and right water collector | ||
5 | Unclip clips (7) | ||
6 | Unhook wiring duct (10) | ||
7 | Loosen fuel lines, remove clamp (12) | ||
8 | Remove firewall center section (11), unscrew screws (13), press out clips (14) | When installing the firewall center section ensure that the rubber grommet for the heater feed hose is seated properly. | |
9 | Remove cover on control module box | ||
10 | Remove engine control module and ABS control module | ||
11 | Loosen control module box (15), for this purpose unscrew screws (16) | ||
12 | Remove water collector (4) | When installing water collector (4) ensure that water drain (8 and 9) is seated properly. | |
13 | Reinstall in opposite order |