Adjust front door

AR72.10-P-0550E

Adjust front door

25.11.09

1

Remove striker eye

2

Inspect sizes of gaps at door all round



 Gaps dimensions at hoods, doors and covers

*129589032100

Model 202.01/02/12

AR60.00-P-0700-01E

Model 202.07/08/18

AR60.00-P-0700-01EA

3

Loosen bolts (6) from inner door panel and tighten; adjust gap dimension by moving front door



*BA72.10-P-1001-01A

4

Loosen bolts (3) and tighten; with centering screw (5) on hinge, adjust contour of driver door at hinge side



Door paneling should be flush with contour of front fender or should be located max. 1 mm deeper.

*BA72.10-P-1001-01A



*BA72.10-P-1002-01A

5

Bolt on striker eye

Do not tighten

6

Completely close front door and adjust contour on striker eye by moving striker eye

Door paneling (B) should be flush with front door or should extend max. 1 mm.

7

Tighten striker eye



*BA72.10-P-1004-01A

8

Check contour and fit at window frame (C) in relation to roof paneling and front wall pillar, adjust if possible

The outer lip of the door frame seal should be flush with the edge of the roof paneling.

9

Check door for easy motion

Number

Designation

Models 202.01/02/033/
12/13

Models
202.07/08/093/
18/19

BE60.00-P-1002-01A

Gap dimension

Front door to A-pillar

Dimension "B"

mm

6.0 (+1)

6.0 (+1)

Front door to fender

Dimension "H"

mm

5.0 (+1)

5.0 (+1)

Front door to rear door

Dimension "I"

mm

6.0 (+1)

6.0 (+1)

Front door to roof

Dimension "C"

mm

6.0 (+1)

6.0 (+1)

Rear door to top of side section

Dimension "D"

mm

6.0 (+1)

-

Rear door to side section, bottom

Dimension "J"

mm

5.0 (0.5)

5.0 (0.5)

Fender to A-pillar

Dimension "Q"

mm

-

-

Front door to rear fender

Dimension "P"

mm

-

-

See picture

AR60.00-P-0700-01E

AR60.00-P-0700-01EA

Number

Designation

Model 202

BA72.10-P-1001-01A

Screw on door hinge

Nm

37

BA72.10-P-1002-01A

Centering screw to
door hinge on A-pillar

Nm

25

BA72.10-P-1004-01A

Bolt to lock striker

Nm

28