Remove/install retaining frame control elements in instrument panel center section · ar6810p1031rt · Mercedes-Benz WIS

AR68.10-P-1031RT

Remove/install retaining frame control elements in instrument panel center section

3.8.06

MODEL 251

P68.10-3393-09

Shown on vehicle with COMAND APS USA (with navigation system), code 530 and with comfort automatic air conditioning, code 581

2 Instrument panel center section

6 Connector

7 Connector

10 Bolts

11 Retaining frame control elements

A40/3 COMAND operating, display and controller unit

N22 AAC [KLA] control and operating unit

N22/7 Comfort AAC control and operating unit

N72/1 Upper control panel control unit

P68.10-3394-01

Shown on vehicle with COMAND APS USA (with navigation system), code 530 and with comfort automatic air conditioning, code 581

12 Eye

Modification notes

26.7.06

"Disconnect/connect ground line for battery and "Perform basic programming" eliminated

Steps 2 and 8

 	Remove/install
	Notes on avoiding damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Switch off ignition and remove the transmitter key from the EIS [EZS] control unit	 On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
2	Remove COMAND operating, display and controller unit (A40/3) or radio		AR82.60-P-7502RT
3	Unlock connector (6, 7) and disconnect, lay instrument panel center section (2) with upper control panel control module (N72/1) and AAC [KLA] control and operating unit (N22) or comfort AAC [KLA] control and operating unit (N22/7) down to side
4	Remove screws (10)
5	Remove retaining frame control elements (11) from center console, remove cable	 Installation: The latch on the top of the retaining frame control elements (11) should be seated correctly in the eye (12) in the center console before installing bolts (10).
6	Install in the reverse order