1 | Hardtop pop-out window |
2 | Pushbutton |
S60.30-0332-04
S60.30-0333-09
1 | Hardtop pop-out window | 4 | Gas-filled strut | 6 | Bolts | ||
3 | Retainer | 5 | Nuts |
S60.30-0334-08
7 | Nuts | 9 | Lock | a | Dimension (approx. 2 mm) | ||
8 | Lock striker bracket | 10 | Lock striker | b | Dimension (approx. 2 mm) |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Warning | Risk of injury from fingers being pinched or jammed when working on gas struts under pressure | Only remove and install pneumatic springs when they are not under tension and when the components are properly secured. | |
| Remove/install | ||
1 | Open the hardtop pop-out window (1). | To do this, actuate push button switch (2). | |
2 | Remove the pneumatic springs (4) from the hardtop pop-out window (1). | To do so, pry off the respective retainer (3) with a suitable tool. | |
Secure the hardtop pop-out window (1) against falling down. | |||
3 | Unscrew nuts (5). | Nut to bolt, holder for passenger-side pop-out window on hardtop | |
4 | Remove the hardtop pop-out window (1). | To do this, remove screws (6). | |
5 | Install in the reverse order. | ||
Adjust | |||
6 | Adjust the hardtop pop-out window (1). | If required. | |
To do this, loosen the nuts (7) until the lock striker (10) can be moved. | |||
Maintain the dimensions (a, b) between the bracket lock striker (8) and lock (9). | |||
Nut, lock striker to passenger-side pop-out window on hardtop | |||
| Check | ||
7 | Perform function test of the electric component parts of the hardtop pop-out window (1). |
참조 문서
- as0000z001101a 후드, 도어, 커버, 슬라이딩 루프 탈, 장착 및 설정작업 시 손가락이 끼이거나 눌려서 입을 수 있는 상해 위험
- as0000z001201a 프리텐션 하의 가스 압력 스프링에서 작업 시 끼이거나 눌려서 입을 수 있는 상해 위험