D65.10-1188-06
The following operation steps are shown on model 906.733 on the left rear side roof paneling (1) and they must be performed in a similar manner for any damage to the right side.
The following 2 steps are only performed if vehicle side with load compartment sliding door is damaged.
1 Punch holes on rear side roof paneling (1) with dia. 6 mm (area B1).
2 Grind crosshatched areas on rear side roof paneling (1) down to bare metal around holes.
D65.10-1167-09
Dimension:
a approx. 8 mm
3 Mark separation lines on rear side roof paneling (1) (areas B and C).
4 Cut rear side roof paneling (1) at connecting points (areas B and C).
5 Punch holes on rear side roof paneling (1) with dia. 6 mm (area A).
D65.10-1171-09
6 Punch holes on rear side roof paneling (1) with dia. 6 mm (area D).
D65.10-1175-09
7 Punch holes on rear side roof paneling (1) with dia. 6 mm (area E).
D65.10-1181-09
8 Grind mating surfaces on rear side roof paneling (1) down to bare metal in crosshatched area.
9 Grind crosshatched areas on rear side roof paneling (1) down to bare metal around holes.
D65.10-1185-09
10 Grind crosshatched areas on rear side roof paneling (1) down to bare metal around holes.