Commercially available tools
Number | Designation | |
WH58.30-Z-1007-06A | Reversible ratchet | |
WH58.30-Z-1001-11A | Double end box wrench, offset, 17 x 19 mm |
Workshop equipment
WE58.40-Z-1057-01A | Celette straightening bracket set 7169.300 (model 169, 245) |
WE58.40-Z-1008-03A | Pneumatic ratchet |
P60.10-2122-09
Set up of straightening tool and multi-Z-elements (front)
1 Basic carrier for straightening tool 3
2 Basic carrier for straightening tool 4
3 Mount for left front longitudinal member
4 Mount for right front longitudinal member
5 Left front integral carrier mount
6 Right front integral carrier mount
7 Locating pin for right front frame-type integral support
9 Left front spring strut dome mount
10 Right front spring strut dome mount
11 Guide pins for spring strut dome mount
12 Right center integral carrier mount
13 Left center integral carrier mount
14 Check pin on front longitudinal member
15 Locating pins for rear and center frame-type integral support mount
17 Left rear integral carrier mount
18 Right rear integral carrier mount
21 Basic carrier for left front jack tube
22 Basic carrier for right front jack tube
23 Right and left front jack tube
24 Check bore mount
25 Test pin on check bore
Set up of straightening tool and multi-Z-elements (rear)
19 Spacer ring on mount for rear axle carrier threaded connection
26 Right center longitudinal member mount
27 Left center longitudinal member mount
28 Basic carrier for right rear jack tube
29 Basic carrier for left rear jack tube
30 Right and left rear jack tubes
31 Mount for rear axle carrier threaded connection
34 Mount for right rear shock absorber
35 Mount for left rear shock absorber
36 Locating and test pin for rear shock absorber
37 Left rear longitudinal member mount
38 Right rear longitudinal member mount
39 Spare wheel recess mount
40 Bottom rear end mount
41 Left top rear end mount
42 Right top rear end mount
43 spacers (for installing cross member)
B70 Guide pins for multi-Z-elements
1 Install multi-Z elements and straightening set.
Number and position of MZ elements and straightening tools are given in the associated Celette setup plan.
Multi-Z elements:
When installing multi-Z elements on straightening bench observe direction of arrow on multi-Z elements
The parts numbers of the multi-Z elements are cast in at side
Straightening tool:
Arrows for straightening tool always toward direction of travel
In addition to the straightening tool number, the straightening tool for the left side have the letter "L" next to the arrow
The position number in combination with the 8-digit reference number (e.g.: 7169.7001), is also the order number for replacement parts
Always setup the right side of the straightening bench analog to the left side.