ar4710w0004h

Remove/install filling connection

유형 ar · 주제 47.10 · 버전 0200 · 2009-09-02

적용 대상: ENGINE 902.9, 906.9 in MODEL 957 with CODE (MS8) natural gas engine

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 1 엔진 › 47 연료 시스템, 드라이브 트레인 에너지 공급 › 47.10 연료탱크 — 시리즈 902 (모델 9**) · 시리즈 906 (모델 9**) · 시리즈 957

EinPAS 16 연료/에너지 공급, 엔진 › 16.10 연료 공급 › 16.10.40 연료 탱크/주입 장치 — 시리즈 902 (모델 9**) · 시리즈 906 (모델 9**) · 시리즈 957

AR47.10-W-0004H

Remove/install filling connection

7.8.09

ENGINE 902.9, 906.9 in MODEL 957 with CODE (MS8) natural gas engine

Remove/install filling connection

W47.10-1011-04

1 Filling connection

2 High-pressure gas line

3 Bracket

4 Electrical line

Modification notes

30.7.09

Note on threaded pipe connections for gas pressure lines - altered.

AH47.25-N-0001-01A

Check the gas system for leaktightness in accordance with the national regulations - added.

Step 9

Remove/install

Danger!

Risk of explosion caused by escaping natural gas or by overheated compressed-gas tanks when working on natural gas powered vehicles. Risk of frostbite to parts of the body caused by escaping natural gas and by touching components near the valves when emptying compressed-gas tanks. Risk of poisoning or risk of suffocation caused by inhaling natural gas.

Remove any sources of ignition.

Ensure that the work area is adequately ventilated.

Wear heat protective gloves.

AS00.00-Z-0018-01A

Notes on work safety regulations for vehicles with natural gas-powered engines

AH00.10-N-1000-04A

Note on threaded pipe connections of gas pressure lines

AH47.25-N-0001-01A

1

Close gas shutoff valves at compressed-gas tanks

AR47.10-W-0005H

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

2

Start engine and run on idle until it engine goes off by itself

In this way residual gas is used up in the lines and components.

3

Switch off ignition

4

Separate cable tie for the electrical line (4) from the compressed-gas tank unit

5

High-pressure gas pipe (2) to filling connection (1)

Installation: Install high-pressure gas line (2) tension-free.

6

Remove bracket (3)

Installation: Replace sealing ring.

7

Take out filling connection (1) towards the front

8

Install in the reverse order

9

Check gas system in accordance with the national regulations for leaktightness

In Germany the GAP is performed according to §41a of the German vehicle licensing regulations.

참조 문서