Remove/install pressure sensor at ABD hydraulic unit

AR42.30-D-9865A

Remove/install pressure sensor at ABD hydraulic unit

27.4.12

 

Remove, Install

Danger!

Risk of poisoning caused by swallowing brake fluid. Risk of injury caused by brake fluid coming into contact with skin and eyes

Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid.

AS42.50-Z-0001-01A



Brake fluid notes

AH42.50-P-0001-01A



Notes on repairs to brake system

AH42.00-P-0003-01A



Important notes concerning repair work on the antilock brake system (ABS)

AH42.30-N-0002-01A

1

Unplug connector (1)

 Press side tab of connector to disengage.

 Installation: Tab of connector must latch audibly into place.

AR42.30-D-8252-03C

2

Remove pressure sensor (2)

 Seal off connection at hydraulic unit to prevent any soiling.



*BA42.30-N-1006-03A

 Installation: Thread and sealing surface at pressure switch and hydraulic unit must not exhibit any signs of damage.

Reworking is not permitted.

If a part is damaged it must be replaced.

3

Bleed brake system, check for leaks and proper function

 Start the engine to carry out function check.

Warning lamps must go out.

Press the brake pedal firmly several times.

Warning lamps must not light up.

AR42.10-D-0010A

4

Check fluid level in reservoir and correct if necessary



AP42.50-D-4210A

5

Connect STAR DIAGNOSIS, read and erase diagnostic trouble code memory

6

Print out protocol

Number

Designation

Models
690.6, 901.6,
902.6, 903.6,
904.6, 905.6
with ABS/ABD,
code BB0

BA42.30-N-1006-03A

Pressure sensor to hydraulic unit

M101

Nm

20