055 589 03 61 00
Puller device
055 589 05 61 00
Supplementary device
Produtos para reparos
Número | Denominação | Número de pedido |
BR00.45-B-1014-06A | Syntheso GL EP1 grease, green color (free of mineral oil) | Knorr II32793 |
B42.10-0295-03
To install the type “2” rubber bushing (6a) follow the work steps 1 and 2:
1 The housing and the rubber bushing must be clean.
2 Insert the new rubber bushing type “1” (6a) in the tool (T21). With a hammer apply moderate strikes on the tool (K21) in the direction of the arrow until reaching the bushing's final position in its housing, indicated in the upper part (6a).
The version “2” rubber bushing, part (6a) utilized in SN7000 brake calipers, is only applied to the front axle of vehicles O500. All other SN7000 brake calipers utilize the type “DU” bushings, part (6b).
B42.10-0296-03
To install the type “DU” bushing (6a) follow the work steps 3 to 6:
3 The housing in the brake caliper and the “DU” type bushing (6b) must be perfectly clean.
4 Position the set of tools (K13) with the plain washer (AL), (K19), (K22), and next, place the new “DU” type bushing (6b), from the opposite side place the tool (K17) and finally (K14).
5 Confirm the correct positioning of the tools before starting installing the bushing.
6 Turn the (K13) tool hexagon with an appropriate socket and install the “DU” type bushing, part (6b) in its seat in the brake caliper.
B42.10-0419-03
To install the type “1” rubber bushing (6a) in the SB7000 brake calipers follow the work steps 7 to 9:
7 The housing and the type “1” rubber bushing (6c) must be clean.
8 Lubricate only the internal part of the new rubber bushing with specified grease.
Pay special attention in the lubrication of the type “1” bushing (6c). Utilize only specified grease from the repair kit.
9 Deform the new type “1” rubber bushing (6c) and insert it in the housing in brake caliper observing the correct positioning in the groove (A) and bushing end (B), which must protrude from the caliper.