1 | Bolt (fixed bearing) |
2 | Metal cover |
3 | Bolt (movable bushing) |
4 | Brake caliper |
5 | Brake bracket |
B42.10-0504-11
| Remove | ||
1 | Remove the brake support (5) with the brake caliper (4) |
| |
2 | Drill the center of the metal cover (2) with a fine slitter | When drilling the metal cover (2), take care to not damage the corners of the housing. | |
During the drilling, the cover may be displaced inwards by approximately 10 mm. | |||
3 | Remove the metallic cover (2) from the fixed bushing | A screwdriver can be used as a lever. | |
4 | Loosen the screws (1 and 3) | ||
5 | Remove the brake caliper (4) from the holder (5) | ||
| Clean | ||
6 | Correctly clean the housing | The housing must be free of grease. | |
| Install | ||
7 | Install the brake caliper (4) in the holder (5) | ||
8 | Install new screws (1 and 3) | Before installing new bolts micro-encapsulation, the threaded perforations must be opened. | |
Front axleBrake caliper bolt | |||
Rear axleBrake caliper bolt | |||
9 | Manually press the brake caliper (4), toward the brake support (5) as much as possible and install a new metal cover (2) | The internal hood must be compressed in order to prevent air infiltration. | |
Utilize an appropriate mandrel. | |||
In case of warping or damage to the new metal cover (2) during installation: | |||
| |||
Install other metal cover (2). | |||
10 | Install the brake support (5) with the brake caliper (4) |
|