Check values for propeller shaft alignment sleeve
Number | Designation | Model 171 | ||
BE41.10-P-1001-02E | Insertion dimension "a" from face end of alignment sleeve to joint flange | Front propeller shaft | mm | 26.8 |
Rear propeller shaft | mm | 23.3 | ||
See picture | - | |||
P41.10-0211-01
1 Measure and note dimension "a".
The specified insertion dimension for installation may deviate depending on the thickness of the flexible couplings.
P41.10-0014-01
2 Knock centering sleeve out of propeller shaft using a flat chisel (arrow).
P41.10-0015-01
If the centering sleeve cannot be knocked out using the chisel:
3 Drill a hole (dia. 10 mm) 15 mm from the end face of the centering sleeve (10) at right-angles through the centering sleeve.
P41.10-0016-01
4 Insert a drift through the hole and lever the centering sleeve (10) out of the propeller shaft using two assembly levers.