시리즈
ko
ar3530b430102ga
Detach tapered roller bearing from ring gear
유형 ar · 주제 35.30 · 버전 0104 · 2019-04-20
적용 대상: Rear axle 741.710 in model 958 Rear axle 746.209/231/233/305 in model 934.2, 938.1, 958 Rear axle 746.213/230 in model 934.2 Rear axle 746.213/230 in model 958.2/4 except code ZC8 (New Final Drive-Top Performance Light) Rear axle 746.218/225 in model 382.1, 634.0 Rear axle 748.590/594 in model 934.2, 958.4
“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.
위치
기능 그룹 2 섀시 › 35 뒷차축 › 35.30 구동장치, 구동축 — 시리즈 382 (모델 1**) · 시리즈 634 (모델 0**) · 시리즈 934 (모델 2**) · 시리즈 938 (모델 1**) · 시리즈 958
EinPAS 17 드라이브 트레인/액슬 › 17.51 뒤차축 › 17.51.65 뒤차축 기어/액슬 드라이브 샤프트 — 시리즈 382 (모델 1**) · 시리즈 634 (모델 0**) · 시리즈 934 (모델 2**) · 시리즈 938 (모델 1**) · 시리즈 958
엔진/변속기에도 적용: 741 710, 746 209, 746 213, 746 218, 746 225, 746 230, 746 231, 746 233, 746 305, 748 590, 748 594
AR35.30-B-4301-02GA
Detach tapered roller bearing from ring gear
Caution
Risk of injury caused by scraping or cutting body parts on sharp vehicle parts
Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
AS00.00-Z-0017-01A
Rear axle
741.710 in model 958
Rear axle
746.209/231/233/305 in model 934.2, 938.1, 958
Rear axle
746.213/230 in model 934.2
Rear axle
746.213/230 in model 958.2/4
except code ZC8 (New Final Drive-Top Performance Light)
Rear axle
746.218/225 in model 382.1, 634.0
Rear axle
748.590/594 in model 934.2, 958.4
The differential tapered roller bearings must be replaced as a set.Remove
1
Use the pressure part as a support on the crown gear (1).
Ensure the correct pressure part position when fitting it on the differential.
2
Install the puller claws on the underside of the taper roller bearing cage (2) .
3
Support the puller over the pressure part and pull the taper roller bearing (2) out of the differential case (1).
참조 문서
