시리즈
ko
ar3530b046401b
Remove/install adjustment screw on ring gear
유형 ar · 주제 35.30 · 버전 0102 · 2019-02-01
적용 대상: Rear axle 746.960/961/964 in model 693.184/191/195, 695.043 Rear axle 746.962 in model 386.014 Rear axle 746.964 in model 693.144 Rear axle 746.966 in model 693.128, 695.014 Rear axle 772.110 in model 695.302 Rear axle 772.115 in model 958
“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.
위치
기능 그룹 2 섀시 › 35 뒷차축 › 35.30 구동장치, 구동축 — 시리즈 386 (모델 014) · 시리즈 693 (모델 128, 144, 184, 191, 195) · 시리즈 695 (모델 014, 043, 302) · 시리즈 958
EinPAS 17 드라이브 트레인/액슬 › 17.51 뒤차축 › 17.51.65 뒤차축 기어/액슬 드라이브 샤프트 — 시리즈 386 (모델 014) · 시리즈 693 (모델 128, 144, 184, 191, 195) · 시리즈 695 (모델 014, 043, 302) · 시리즈 958
엔진/변속기에도 적용: 746 960, 746 961, 746 962, 746 964, 746 966, 772 110, 772 115
AR35.30-B-0464-01B
Remove/install adjustment screw on ring gear
Rear axle
746.960/961/964 in model 693.184/191/195, 695.043
Rear axle
746.962 in model 386.014
Rear axle
746.964 in model 693.144
Rear axle
746.966 in model 693.128, 695.014
Rear axle
772.110 in model 695.302
Rear axle
772.115 in model 958
Ring gear with differential
Number
Designation
Axles 746.96; 772.110/115/116
BA35.30-B-1004-05H
Clamp nut of the ring gear thrust bolt
Nm
200...260
1
Slacken the jam-nut (3) and remove the bolt (2) with the sliding pad (4) from the differential carrier housing (1).
Install
2
Install the bolt (2) with the sliding pad (4) and the jam-nut (3) in the differential carrier housing (1).
If necessary, install a new sliding pad (4).
3
Tighten the bolt (2) until the sliding pad touches on the ring gear surface.
4
Unscrew the screw 1/3 turn (120°).
This will provide the specified clearance between slider (4) and the crown gear.
5
Tighten the jam nut (3) to block the bolt.
Hold the screw (2) with a wrench to not alter its adjustment position.
