AR33.30-W-0458-04A | Preparing drive pinion for installation | ||
| Clamp for clamping the assembled drive pinion |
Pulling device
745 589 00 33 00
D35.30-0121-01
1 Fit clamp (16) around outer races of tapered roller bearings and clamp drive pinion in a vise.
2 Fasten puller (17) on coupling flange (9) with two bolts (18) so that the bolts press on the threaded ring (10) with a force of approx. 30 Nm and the puller (17) lies flat against the coupling flange (9).
This clamps the outer races of the tapered roller bearings in the axial direction, and prevents the halves of the compensating ring from slipping into the oil groove when the drive pinion is installed.
D35.30-0120-01
1 Drive pinion 12 Spacer ring
2 Crown wheel 13 Compensating ring halves
3 Inner tapered roller bearing 14 Shims
4 Outer tapered roller bearing 15 Cylindrical roller bearing
5 Tab washer
6 Shim
7 Radial sealing ring
8 Collared nut
9 Coupling flange
10 Threaded ring
11 Threaded ring oil groove