Removing and installing rubber mount on wishbone

유형 ar · 주제 33.20 · 버전 0107 · 2001-08-09

적용 대상: MODEL 901, 902 with FRONT AXLE 730.408 /410 MODEL 902, 903 with FRONT AXLE 730.409 MODEL 903 with FRONT AXLE 730.413 MODEL 904 with FRONT AXLE 730.411 /414 MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG1) Engageable all-wheel drive MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG2) Permanent all-wheel drive MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG3) Reduction ratio for all-wheel drive MODEL 905 with FRONT AXLE 730.606 MODEL 690.6 with FRONT AXLE 732.2

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 2 섀시 › 33 앞차축 › 33.20 휠가이드, 허브 — 시리즈 690 (모델 6**) · 시리즈 901 · 시리즈 902 · 시리즈 903 · 시리즈 904 · 시리즈 905

EinPAS 17 드라이브 트레인/액슬 › 17.50 앞차축 › 17.50.41 컨트롤 암/핸들바/스태빌라이저 — 시리즈 690 (모델 6**) · 시리즈 901 · 시리즈 902 · 시리즈 903 · 시리즈 904 · 시리즈 905

엔진/변속기에도 적용: 730 408, 730 409, 730 410, 730 411, 730 413, 730 414, 730 606, 732 2**

AR33.20-D-1452-01A

Removing and installing rubber mount on wishbone

730 589 00 43 00

Press-in/out tool

D33.20-0001-11

1 Wishbone

2 Rubber mount

D33.20-0023-01

Removing

1 Fit wishbone (1) with drift (01) on the  remover (03) and press out rubber mount.

D33.20-0024-01

Installing

2 Coat new rubber mount with oil.

3 Place  in the press in the sequence illustrated with the wishbone and rubber mount.

4 Press rubber mount into wishbone as far as the stop on the drift.

D33.20-0026-01

D33.20-0025-01

5 Insert drift  into rubber mount from below.

6 Place counterholder  on rubber mount and press back rubber mount until it is seated in the center of the wishbone.

D33.20-0027-01

 If the rubber mount is pressed too far through, turn  over and press rubber mount back to the correct position.