S32.35-0001-06
1 Stabilizer
2 Flange
3 Rubber mounts
4 Bolts M8 x 20
5 Torque struts
6 Nuts M10
| Remove/install | ||
1 | Remove right wheel | On right-hand drive vehicles, remove left wheel. | |
2.1 | Detach splash protection from longitudinal member | Engine 611 | |
3.1 | Detach lower noise encapsulation in engine compartment | Engine 111 | |
4.1 | Detach boost pressure control pressure transducer from bracket | Engine 611 | |
5 | Unscrew bracket (2) and detach rubber mount (3) from stabilizer bar (1) | On engine 611, observe installation position of the additional bracket for the boost pressure control pressure transducer. | |
| |||
6 | Unscrew nuts (6) at bolted connection between torque struts (5) and stabilizer bar (1) and pass out torque struts (5) | | |
7.1 | Remove front exhaust system or oxidation catalytic converter. | Engine 111 | |
Engine 601 | |||
7.2 | Remove exhaust collector | Engine 611 | |
8 | Pass out stabilizer bar (1) to the right side | On right-hand drive vehicles, pass out stabilizer bar to the left. | |
With code H12 (hot-water auxiliary heater), apply sliding compound at the contact point between the stabilizer bar (1) and the coolant hoses. | |||
9 | Install in the reverse sequence |
Front axle anti-roll bar