ar3235s0313p

Remove/install stabilizer bar elastomer bearing on rear axle

유형 ar · 주제 32.35 · 버전 0101 · 2019-01-02

적용 대상: Model 470, 471

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 2 섀시 › 32 서스펜션 › 32.35 스태빌라이저 — 시리즈 470 · 시리즈 471

EinPAS 17 드라이브 트레인/액슬 › 17.51 뒤차축 › 17.51.40 컨트롤 암/핸들바/스태빌라이저 — 시리즈 470 · 시리즈 471

AR32.35-S-0313P

Remove/install stabilizer bar elastomer bearing on rear axle

18.12.2018

Model

470, 471

Remove/install stabilizer bar elastomer bearing on rear axle

Shown on model 470

1

Screw

2

Screw

3

Bracket

4

Stabilizer bar

5

Elastomer bearing

6

Spacer

S32.35-4530-06

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Warning

Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension

Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves.

AS00.00-Z-0001-01A

Remove/install

1

Raise vehicle.

AR00.60-S-1000-04P

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01P

2

Loosen screws (1) a few turns.

Screw/bolt, rear axle stabilizer bar bracket to rigid axle

*BA32.35-N-1001-03P

3

Remove brackets (3).

To do so, remove screws (2) and remove bracket (3) downwards.

Screw/bolt, rear axle stabilizer bar bracket to rigid axle

*BA32.35-N-1001-03P

4

Remove elastomer bearings (5) from stabilizer bar (4).

Installation: The lugs (arrows) of the elastomer bearings (5) must point downwards.
The elastomer bearings (5) must contact the spacers (6) at the side, as shown.

5

Install in the reverse order.

Rear axle stabilizer bar

Number

Designation

Model 470, 471

BA32.35-N-1001-03P

Screw/bolt, rear axle stabilizer bar bracket to rigid axle

Nm

150

참조 문서