Remove/install front anti-roll bar

AR32.35-D-2050A

11.11.09

MODEL 901, 902, 903, 904

MODEL WD5WD141, WD5WD241, WD5WD341, WD5WD641, WD5WD741,
WD1XD141, WD1XD241, WD1XD341, WD1XD441, WD1XD541, WD1XD641, WD1XD741,
WD2YD141, WD2YD241, WD2YD341, WD2YD441, WD2YD541, WD2YD641, WD2YD741

MODEL 690.6

D32.35-0001-06

1 Nut

2, 6 Rubber bushing

3 Link rod

4 Screw

5 Bearing shell

7 Stabilizer

	Removing
1	Remove bolts (4) of bearing shells (5) on front axle beam, fold up bearing shells
2	Press rubber mounts (6) outwards out of the brackets	 To facilitate pressing out, coat the anti-sway bar with assembly oil.
3	Press link rods (3) off the retaining pins onto the spring end stop plates
4	Pull off rubber mounts remaining on the spring end stop plates
5	Detach link rods (3) on anti-sway bar (1), replace rubber mounts if necessary		AR32.35-D-2050-02A
	Install
6	Assemble link rods (3) on anti-sway bar (1)		AR32.35-D-2050-02A
7	Install anti-sway bar on front axle		AR32.35-D-2050-03A
			*BA32.35-N-1001-02E

 Front axle stabilizer

Number	Designation			Model 690, 901, 902, 903, 904	Model WD1/WD2/ WD3/WD6/ WD7/XD1/ XD2/XD3/ XD4/XD5/ XD6/XD7/ YD1/YD2/ YD3/YD4/ YD5/YD6/ YD7


BA32.35-N-1001-02E	Bolt or nut, anti-roll bar bearing shell to front axle beam	M8	Nm	30	30

참조 문서