Remove/install rear spring

AR32.20-S-0230S

Remove/install rear spring

22.11.2019

Model

636

Model

639

except code CL0 (Rear air suspension, lowerable and liftable)

Shown on vehicle with code (ZG2) Permanent all-wheel drive

1

Tensioning device

2

Spring

3

Rubber stopper

 

Remove/install

 Warning

Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension

Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves.

AS00.00-Z-0001-01A

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

1

Raise vehicle with vehicle lift

AR00.60-S-1000S

2

Install tensioning device (1)

 Tensioning device

*203589013100

 Clamping plates

*639589006300

3

Remove spring (2)

 Installation: Ensure correct position of the spring (2).

4

Detach rubber stops (3) from spring (2)

 Installation: Check rubber stops (3) for wear and damage, replace if necessary.

5

Install in the reverse order