Test values for throttle control - chassis-side
Number | Designation | Engine 402.970 | Engine 402.970 with EMR | ||
BE30.12-N-1001-01B | Distance | Accelerator pedal stop screw to vehicle floor | mm | 1...2 | 1...2 |
BE30.12-N-1003-01B | Adjustment dimension | Linkage length, accelerator pedal to position sensor | mm | 248.5...251.5 | 248.5...251.5 |
Test values for throttle control - chassis-side
Number | Designation | Engines 441.980, 446.938 | ||
BE30.12-N-1001-01B | Distance | Accelerator pedal stop screw to vehicle floor | mm | 1...2 |
BE30.12-N-1003-01B | Adjustment dimension | Linkage length, accelerator pedal to position sensor | mm | 248.5...251.5 |
T30.12-0006-02
The emergency operation cable (4) fitted to vehicles with EMR must not be attached to the lever of the position sensor during this setting.
1 Depress accelerator pedal as far as the first perceptible resistance (kickdown point).
If the stop screw (1) touches the vehicle floor before this, it must be turned further into the accelerator pedal.
2 Measure play (A) between stop screw (1) and vehicle floor, and adjust if necessary.
- Play too small: Turn stop screw (1) into the accelerator pedal.
- Play too large: Turn stop screw (1) out of the accelerator pedal.
3 Depress accelerator pedal until stop screw is touching vehicle floor (beyond kickdown point).
In this position, the accelerator pedal must not be resting on the end stop of the position sensor. If necessary, slightly alter length of linkage (B).
If the linkage is replaced, carry out basic setting of length of linkage.