AR28.50-P-1020A | Disassembling, assembling synchromesh of input shaft | 6.10.98 |
MODEL 460, 461 with TRANSFER CASE 750.60
P28.10-2134-06
1 Shift sliding sleeve
2 Synchronizer ring
3 Ball (synchronizer body)
4 Synchronizer body
5 Synchronizer ring
6 Spring
7 Ball pivot
8 Driver
P28.50-2086-09
1 Shift sliding sleeve
5 Synchronizer ring
6 Spring
7 Ball pivot
8 Driver
9 Synchronizer cone with driver ring
10 Driver in driver ring
11 Ground teeth
| Disassembling | ||
1 | Remove both synchronizer rings (2) | ||
2 | Remove shift sliding sleeve (8) | Pay attention to driver (7), ball pivot (6) and spring (5) | |
3 | Clean, check all parts and replace if necessary | ||
| Assembling | ||
4 | Insert spring (5), ball pivot (6) and driver (7) | ||
5 | Place shift sliding sleeve (8) on driver ring so that the drivers are in front of the center of the three ground teeth (4) | ||
6 | Press back each ball pivot (6) and slide on shift sliding sleeve (8) | ||
7 | Place both synchronizer rings (2) corresponding to the driver (7) | The synchronizer cone for the off-road gear also has nine balls on the outer taper. This is installed on the side of the driver where the oil grooves are present. |