ar2819s1003ps

Remove/install transfer case control unit

유형 ar · 주제 28.19 · 버전 0100 · 2018-06-07

적용 대상: Model 470, 471 with engine 642

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 2 섀시 › 28 트랜스퍼 케이스 › 28.19 변속기　전기장치 — 시리즈 470 · 시리즈 471

EinPAS 17 드라이브 트레인/액슬 › 17.22 트랜스퍼 케이스 › 17.22.11 컨트롤 유닛/릴레이 — 시리즈 470 · 시리즈 471

엔진/변속기에도 적용: 642 ***

AR28.19-S-1003PS

Remove/install transfer case control unit

23.05.2018

Model

470, 471 with engine 642

Remove/install transfer case control unit

1

Transfer case

2

Electrical connector

3

Bolts

N45

Transfer case (VG) control unit

P33.00-2152-06

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Perform commissioning of transfer case control unit (N45) using vehicle diagnosis system.

If the transfer case control unit (N45) is replaced.

AD00.00-S-2000-06P

2

Put transmission into neutral position.

3

Disconnect ground line on battery.

AR54.10-S-0003P

4

Lift vehicle with lifting platform.

AR00.60-S-1000-04P

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01P

5

Release and disconnect electrical connector (2) of transfer case control unit (N45).

6

Unscrew bolts (3).

Bolt, transfer case control unit to transfer case

*BA28.40-N-1006-01P

7

Remove transfer case control unit (N45) downwards.

Installation:
The guides of the transfer case control unit (N45) must engage in the groove in the transfer case (1).
Damage will otherwise occur.

Installation: Replace O-rings.

8

Install in the reverse order.

Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

9

Perform engine test run; while doing so, check transfer case (1) for proper operation and leak tightness.

Transfer case housing

Number

Designation

Model 470, 471 with engine 642

BA28.40-N-1006-01P

Bolt, transfer case control unit to transfer case

Nm

22

참조 문서