000 589 29 33 00
Inner puller
000 589 34 33 00
Counter-support
711 589 00 09 00
Tubular wrench
D26.45-0050-01
1 Remove the plug (1) upwards with an \\appropriate screwdriver.
2 Insert an M8 screw (2) through the open orifice and screw-it on a few turns on the shaft integrated in the intermediated gear (3).
D26.45-0051-01
3 Apply light blows on the threaded screw (2) to release the intermediate gear (3) downwards, next remove the screw.
4 Remove the needle bearings (4) and (5) from underneath.
D26.45-0052-12
5 Remove the thrust washer (8), the drive gear (7) and the shifting sleeve (6) through the PTO's flange opening.
D26.45-0053-12
6 Remove the threaded bushing (9) with the tubular wrench
7 Remove the helical spring (10).
D26.45-0054-12
8 Remove the control bar (11) from inside to the outside, with an appropriate drift.
D26.45-0055-12
9 Remove the cylindrical pin (12).
10 Remove the shifting fork (13) through the PTO's flange opening.
D26.45-0056-01
11 Remove the plug (14) with light upward blows.
12 Remove the pressure pin of the lever lock mechanism (15) upwards.
D26.45-0057-12
13 Remove, with light blows and an appropriate drift, the cylinder roller bearing (16) through the threaded hole on the PTO's flange(arrow).
14 Remove the outside race of the bearing (18) of the countershaft with the internal puller and the counter-support .
15 Remove the outside race of the bearing (17) with the internal puller and the counter-support .