1 | Clutch booster |
2 | Clutch actuation hydraulic line |
3 | Pneumatic line of the clutch booster |
4 | Clutch wear indicator sensor |
T25.20-0025-03
| Remove/install | ||
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
1 | Release pressure from secondary pneumatic circuit | ||
| Brake fluid notes | ||
To release pressure, open secondary pneumatic circuit reservoir bleeder valve. | |||
2 | Remove the lining under the engine compartment | Carry out only the work steps necessary for the removal of the lining under the gearbox. | |
3 | Loosen the electrical connector in the clutch wear indicator sensor (4) | Installation: If a new clutch booster is installed (1) or clutch parts are replaced: | |
| |||
The clutch return travel must be stored in the vehicle control unit (FR). | |||
4 | Disconnect hydraulic line (2) from the clutch booster (1) | Catch the running off hydraulic fluid in a suitable container. | |
5 | Disconnect the pneumatic line (3) from the clutch booster (1) | Installation: Replace sealing rings. | |
6 | Loosen the bolts and remove the clutch booster (1) | . | |
.Clutch booster attachment bolt | |||
7 | Install on the reverse order | ||
8 | Bleed the clutch system |
참조 문서
- ah4250b000101a
- as4250z000101a 브레이크액 음용으로 인한 중독 위험, 브레이크액이 피부 또는 눈에 닿아 발생하는 상해 위험