S25.19-0002-08
Shown on model 470 with transmission 700.78 |
1 | Electrical connector | 4 | Pedal bracket | |
2 | Jam nut | 5 | Clutch pedal | |
3 | Switches | 6 | Pin |
Warning | Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Remove driver kneebag. | ||
2 | Release electrical connector(1) and disconnect. | ||
3 | Loosen counternut (2). | ||
4 | Remove switch (3). | To do so, remove switch (3) from pedal bracket (4). | |
| Install | ||
5 | Install switch (3). | To do so, install switch (3) into pedal bracket (4). The threaded pin must make contact with the pedal stopper (arrow). Do not press the clutch pedal(5) out of the rear end position here. | |
6 | Tighten counternut (2). | ||
Note on calculation of tightening torque when using insertion or socket tools with various effective lengths | |||
Commercially available devices/tools | |||
Jam nut, rear end position clutch pedal button to pedal bracket | |||
| Check | ||
7 | Check whether bolt (6) of threaded rod for clutch master cylinder can be moved to the side easily by hand. | If bolt (6) of threaded rod for clutch master cylinder is stuck: | |
| |||
Replace bolt (6) of threaded rod for clutch master cylinder. | |||
Assembly cleaner | |||
Molykote BR 2 plus grease | |||
8 | Connect electrical connector (1). | ||
9 | Install driver knee airbag. |
참조 문서
- ah0000p001501cw 다양한 길이의 삽입 공구 혹은 소켓 공구를 사용할 때 조임 토크 산출에 관한 지침
- ah6800n000101s 차량 승객실에서의 정비 작업 실행 지침
- ar2520s000501p
- ar9160s0200p
- as0000z000901a 끼임 또는 짓눌림에 의한 상해 위험 또는 극단적인 경우 기계 장치에 손발이 절단되는 상해 위험
- as0000z001701a 모서리가 날카로운 차량 부품에서 절단상과 찰과상으로 인한 상해 위험