ar0708p7008rtb

Remove/install injection system control unit

유형 ar · 주제 07.08 · 버전 0103 · 2007-08-10

적용 대상: ENGINE 642 in MODEL 251

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 1 엔진 › 07 혼합물 처리 › 07.08 제어장치 — 시리즈 251

EinPAS 15 엔진 › 15.45 엔진 매니지먼트 › 15.45.11 컨트롤 유닛/릴레이 — 시리즈 251

엔진/변속기에도 적용: 642 ***

AR07.08-P-7008RTB

Remove/install injection system control unit

25.7.07

ENGINE 642 in MODEL 251

Remove/install injection system control unit

P07.08-2124-06

1 Cover

2 Electrical connector

3 Electrical connector

4 Retaining lug

5 Retaining frame

N3/9 CDI control unit

Remove/install

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof.

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Read out coding of CDI control unit (N3/9)

Only when replacing CDI control unit (N3/9) and if it can be read out using STAR DIAGNOSIS.

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

2

Unclip cover (1)

Do not damage retaining lug at the cover (1).

AR88.10-P-1300RT

3

Disconnect electrical connectors (2, 3) at CDI control unit (N3/9)

To disconnect electrical connectors at CDI control unit (N3/9), pull the locks to the outside.

Installation: Check that the wiring harness gasket is at the correct position.

4

Release retaining lugs (4) and remove CDI control unit (N3/9) from retaining frame (5)

Installation: Ensure correct seating in retaining frame.

5

Install in the reverse order

6

Encode CDI control unit (N3/9)

Only if a new CDI control unit (N3/9) is installed.

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

참조 문서