Remove/install gas temperature sensor

AR07.04-W-0002H

Remove/install gas temperature sensor

17.6.08

 

Remove/install

 Danger!

Risk of explosion caused by escaping natural gas or overheated compressed-gas tanks when working on natural gas powered vehicles. Risk of frostbite to parts of the body caused by escaping natural gas and by touching components near the valves when emptying compressed-gas tanks. Risk of poisoning or risk of suffocation caused by inhaling natural gas.

Remove any sources of ignition.

Ensure that the work area is adequately ventilated.

Wear heat protective gloves.

AS00.00-Z-0018-01A



Notes on work safety regulations for vehicles with natural gas-powered engines

AH00.10-N-1000-04A

1

Close gas shutoff valves at compressed-gas tanks

AR47.10-W-0005H

 Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

2

Start engine and run on idle until the engine goes off by itself

 In this way residual gas is used up in the lines and components.

3

Switch off ignition

4

Open maintenance flap

 Danger!

Risk of injury caused by body parts being pinched or crushed as cab is tilted

Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut.

AS60.80-Z-0001-01A

5

Tilt cab



Notes on tilting the cab

AH60.80-N-0003-01A

6

Remove cover (2) from charge air manifold.

7

Disconnect the electrical connector (1) at gas temperature sensor (B107)

8

Unscrew gas temperature sensor (B107) from the charge air manifold

 Installation: Replace sealing ring.



*BA07.54-N-1007-01A

9

Install in the reverse order

 Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

10

Check gas temperature sensor (B107) for leaktightness

 Apply a foaming agent around the gas temperature sensor (B107), for example, a leak detection spray or soapy water. Start engine and check for blistering at idle speed. If leaks are detected, seal the component concerned.

Number

Designation

Engine
902.9
with code MS8,

Engine 906.9 with code MS8

BA07.54-N-1007-01A

Gas temperature sensor to charge air manifold

Nm

35