ar0330p8001rx

Remove/install flywheel/drive plate

유형 ar · 주제 03.30 · 버전 0100 · 2006-01-24

적용 대상: ENGINE 272, 273 in MODEL 230

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 1 엔진 › 03 파워트레인 › 03.30 플라이휠, 드라이버 디스크, 진동댐퍼, 플라이휠 링기어 — 시리즈 230

EinPAS 15 엔진 › 15.15 연소 엔진 전체/엔진 블럭/크랭크 어셈블리 › 15.15.41 크랭크샤프트/플라이휠/클러치 디스크 — 시리즈 230

엔진/변속기에도 적용: 272 ***, 273 ***

AR03.30-P-8001RX

Remove/install flywheel/drive plate

10.1.06

ENGINE 272, 273 in MODEL 230

Remove/install flywheel/drive plate

P03.30-2111-12

1 Drive plate

1a Bolt

2 Straight pin

3 Threaded tool

Remove/install

1

Remove transmission with torque converter

AR27.10-P-0500RX

2

Install retaining lock for crankshaft/starter ring gear

AR03.30-P-5000RX

3

Remove bolts (1a) from drive plate (1)

Installation: If no tightening angle wrench is available, the bolts can be torqued further by the specified angle in a single operation using a wrench and tommy lever (1a).

To avoid any angle errors, a bending rod torque wrench must not be used for tightening according to angle degrees. This falsifies the tightening torque.

*BA03.30-P-1002-01M

4

Remove drive plate (1) from crankshaft flange

Installation: The cylinder pin (2) determines the installation location of the drive plate (1).

Checking

5

Check threaded union (3) in the drive
plate (1)

In case of damaged or loose threaded unions (3), the drive plate (1) must be replaced.

6

Install in the reverse order

Flywheel, driven plate, vibration damper, starter ring gear

Number

Designation

Engine
272

Engine
273

BA03.30-P-1002-01M

Bolt, starter ringgear/
drive plate to crankshaft

Stage 1

Nm

20

20

Stage 2

Nm

45

45

Stage 3

°

90

90

참조 문서