Remove/install a flywheel

AR03.30-D-8002SF

19.5.09

ENGINE 642.896 in MODEL 906 with TRANSMISSION 711.685

ENGINE 642.992 in MODEL 906 with TRANSMISSION 711.660

D03.30-1125-11

Shown on engine 642.992

1 Flywheel

2 Bolt

3 Guide bearing

4 Retaining lock 

 	Remove/install
1	Remove clutch		AR25.10-S-0050SD
2	Install retaining lock (4)		AR03.30-S-5000SE
3	Remove bolts (2)	 Installation: Replace bolts (2).
			*BA03.30-N-1004-01S
4	Remove retaining lock (4)		*112589034000
5	Take off flywheel (1)	 Installation: Observe correcting seating of flywheel (1).
	Checking
6	Check flywheel (1) for damage and friction surface for wear; replace flywheel (1) if necessary
7	Check guide bearing (3) for damage and wear; replace flywheel (1) if necessary
8	Install in the reverse order
9	Attach STAR DIAGNOSIS, read out fault memory, delete if necessary and perform sensor rotor adaptation in menu item Control unit adaptation	 Only if the flywheel (1) has been replaced.
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-D-2000-04SD

 Flywheel, drive plate, vibration damper, starter ring gear

Number	Designation			Engine 642


BA03.30-N-1004-01S	Bolt, two-mass flywheel/drive plate to crankshaft	Stage 1	Nm	45
		Stage 2	°	90

Retaining lock

112 589 03 40 00