Remove/install a flywheel · ar0330d8002ng · Mercedes-Benz WIS

AR03.30-D-8002NG

Remove/install a flywheel

3.9.08

ENGINES 271.951 in MODEL 906 with TRANSMISSION 711.651

D03.30-1133-08

1 Flywheel

2 Bolts

5 Cylinder pin

3  Retaining lock

4 Guide bearing

 	Remove/install
1	Remove clutch		AR25.10-S-0050SD
2	Install retaining lock (3)		AR03.30-D-5000NG
3	Remove bolts (2)	 Installation: Replace bolts (2). To exclude any risk of an offset angle error, a bending rod torque wrench must not be used for tightening.
		 Installation: If an angle tightener is not available, the bolts (2) can be tightened further by the specified angle in a single operation using a socket wrench and breaker bar.
			*BA03.30-N-1004-01S
4	Remove retaining lock (3)		*602589004000
5	Remove flywheel (1) from crankshaft	 Installation: The installation position of the flywheel (1) is dictated by the cylinder pin (5).
	Checking
6	Check flywheel (1) for damage and friction surface for wear; replace flywheel (1) if necessary
7	Check guide bearing (4) for damage and wear; replace flywheel (1) if necessary
8	Install in the reverse order

 Flywheel, drive plate, vibration damper, starter ring gear

Number	Designation			Engine 271, in model 906


BA03.30-N-1004-01S	Bolt, two-mass flywheel/drive plate to crankshaft	Stage 1	Nm	45
		Stage 2	°	90

Retaining lock

602 589 00 40 00