D03.30-1127-09
1 Vibration damper
2 Center bolt
5 Crankshaft
3 Poly-V belt
4 Crankshaft radial seal
| Remove/install | ||
1 | Remove poly-V belt (3) | ||
2 | Install retaining lock for crankshaft/starter ring gear | ||
3 | Unscrew center bolt (2) | | |
4 | Detach vibration damper (1) from crankshaft (5) | Check contact surface of hub (arrow) for galling or damage; replace vibration damper (1) if necessary. | |
Installation: the installation position of the vibration damper (1) is dictated by a feather key in the crankshaft (5). | |||
5 | Replace front crankshaft radial seal (4) | when replacing the vibration damper (1) or in case of leaks on the crankshaft radial sealing ring (4). | |
6 | Install in the reverse order | ||
| Checking | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
7 | Carry out engine test run and check engine for leaks in area of crankshaft radial sealing ring (4) | When replacing crankshaft radial sealing ring (4). |
Flywheel, driven plate, vibration damper, starter ring gear
참조 문서
- ar0320d3000us
- ar0330d5000us
- ar1322d1202us
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험