220 589 05 99 05
Adapter line pin 1.50 x 0.60 mm
220 589 01 99 60
MQS blade
220 589 01 99 50
Blade holder with clamping pliers
For measurements at the contact (16.5), the adapter line pin 1.50 x 0.60 mm must be used.
P00.19-6771-77
1 | Move retaining cap (16.1) forward in direction of arrow (A) as far as end stop with a suitable tool. |
2 | Release retaining cap (16.1) at side using a suitable tool and remove. |
3 | Unclip cap (16.2) with suitable tool and pull toward rear. |
4 | Remove seal (16.3) from plug (16) using a suitable tool and pull toward rear. |
5 | Insert the blade holder with collet and the MQS blade under the spring shackle (16.4) on the front side of the connector socket (16). Lift spring shackle (16.4) in direction of arrow (B) and hold. |
6 | By pulling the corresponding electric line, unpin contact (16.5) from connector socket (16). |