Check charging cable and vehicle socket

AP54.10-P-5458C

Check charging cable and vehicle socket

06.12.2019

Model

253.99

Show on model 253.992

1a

Charging cable

3

Cap

1b

Charging cable

4

Sequence

2

Charger feed-in socket

5

Lock

 Danger

Risk of explosion caused by escaping hydrogen or overheating of the fuel tanks when working on the hydrogen system. Risk of frostbite to body parts caused by escaping gas and by touching component parts carrying gas when emptying fuel tanks. Risk of asphyxiation caused by inhalation of air diluted by hydrogen. Risk of burn injuries by coming into contact with an invisible pale blue hydrogen flame.

AS00.00-Z-0030-01B

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

Notes on fuel cell system

AH00.00-P-0022-01RFW

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A



Remove

1

Take charging cables (1a) and (1b) out of the vehicle.



Check

2

Check charging cable (1a) over the entire length, plugs and switches for cracks, kinks, bites, cuts, crushed areas, chafe marks and other damage.

If problems occur,



replace charging cable (1a).

 After obtaining special order.

3

Check charging cable (1b) over the entire length, plugs and switches for cracks, kinks, bites, cuts, crushed areas, chafe marks and other damage.

If problems occur,



replace charging cable (1b).

 After obtaining special order.



Install

4

Place charging cables (1a) and (1b) in vehicle.



Check

5

Check charger feed socket (2) for damage.

If problems occur,



Replace charger feed socket (2).

 After obtaining special order.

6

Check that cap (3) is firmly seated on charger feed socket (2).

If problems occur,



Replace charger feed socket (2).

 After obtaining special order.

7

Check drain (4) for clear passage and soiling.


Remove any soiling.
This is because water must not collect in the charger feed socket (2) area.

If problems occur,



rectify the problems.

 After obtaining special order.

8

Check lock (5) by opening and closing cap (3).

If problems occur,



Replace charger feed socket (2).

 After obtaining special order.