AP43.40-D-4356A | Retarder - check gap | 4.11.05 |
MODEL 668, 670
with CODE (BR1) CC 50 retarder
with CODE (BR2) CC 65 retarder
with CODE (BR3) CC 80 retarder
N43.40-2012-11
| Checking | ||
1 | Push rotors towards transmission | Using a suitable tool, push rotors towards the transmission. | |
2 | Check gap (A) | Use feeler gauge to check circumference of gap (a) of both rotors at the four pole plates and calculate an average dimension. | |
If the gap (a) is too large or too small then the gap (a) must be adjusted. | |||
Gap between rotor and stator | |||
Feeler gauge | |||
3 | Push rotors towards rear axle | Using a suitable tool, push rotors towards the rear axle. | |
4 | Check gap (b) | Use feeler gauge to check circumference of gap (b) of both rotors at the four pole plates and calculate an average dimension. | |
If the gap (b) is too large or too small then the gap (b) must be adjusted. | |||
Gap between rotor and stator | |||
Feeler gauge |
Test values for retarder (electric)
Number | Designation | Model | Model | ||
BE43.40-N-1001-01B | Gap between rotor and stator | mm | 0.8 (-0.15) | 1.5 (-0.15) | |
Test values for retarder (electric)
Number | Designation | Model | ||
BE43.40-N-1001-01B | Gap between rotor and stator | mm | 0.8 (-0.15) | |
Commercially available tools