AN43.20-L-1000A | Retrofit fluid reservoir in compressor line between air compressor and air drier | 8.4.04 |
MODEL 668.### ## up to 114068 with CODE (B16) 2-circuit hydraulic brake/2-circuit compressed air brake
MODEL 670.### ## up to 114068 with CODE (B16) 2-circuit hydraulic brake/2-circuit compressed air brake
L43.20-0001-06
1 Fluid reservoir
2 Four-circuit protection valve
3 Bracket
4 Direction of travel
| Remove | ||
1 | Cut through existing compressed-air line between air compressor and air drier using a pipe cutter | Cut out 355 mm in the area of the four-circuit protection valve (2). Deburr pipe ends. | |
| Install | ||
2 | Install bracket (3) with pressure line on vehicle frame | Use existing bore for this. | |
3 | Position fluid reservoir (1) free of tension and tighten | Tighten bolts with sealing rings. | |
| |||
4 | Inspect unit for leaks and operation |
Fluid reservoir
Number | Designation | Models | |
BA43.20-N-1001-01A | Threaded connection, fluid reservoir to pressure line | Nm | 80 |
Parts ordering notes
Part no. | Designation | Quantity |
A 668 430 00 70 | Fluid reservoir assy. | 1 |
N 000000 000093 | Nut N 15017-AL-DBL8451.21 | 2 |
A 001 990 10 67 | Cutting ring | 2 |
A 645 524 09 40 | Bracket on longitudinal frame member | 1 |
A 667 988 00 11 | Rubber pad | 1 |
N 916016 014201 | Clamp N 16016-BRSGU 15/20 | 1 |
N 913023 008002 | Nut M8-10 DB specifications for the supply of materials 9440 40 | 3 |
N 000000 000276 | Bolt M8x20-8.8 DBL9440 40 | 1 |