SI32.20-D-0003A | Service information: Replacing torsion bar mounts | 10.4.12 |
MODEL 906
with CODE (C40) Front axle stabilizer bar
with CODE (C45) Reinforced front axle stabilizer bar
except CODE (ZG1) Engageable all-wheel drive
except CODE (ZG3) Engageable all-wheel drive with gear reduction
D32.20-1133-08
New version
1 Rubber bushing
2 Stabilizer bar
Old version
2 Stabilizer bar
3 Rubber bushing
D32.20-1135-11
2 Stabilizer bar
4 Front axle
A Installed dimension
As of production date 07/2010 a modified rubber mount (1) is fitted onto the front-axle torsion bar. In contrast to the old rubber bushing (3), this is a torsion bearing, which has to be installed and bolted at the zero position. The stabilizer bar (2) is then hooked into the link rods.
In a repair instance, care must be taken to ensure that only the new rubber mounts (1) are installed. Both sides must always be processed.
The bearing shells with bolts are also to be replaced during the change, because the geometry of the bearing shells was changed.
Test and adjustment values for front axle stabilizer bar