D72.29-1122-09
1 | Cable distributor | 6 | Nut | 11 | Electrical connector | ||
2 | Screw-type nipple | 7 | Bolts | 12 | Cable tie | ||
3 | Slider | 8 | Shaft retainers | 13 | Electrical connector | ||
4 | Adjustment screw | 9 | Shaft | M73/1 | Right sliding door drive | ||
5 | Cable (motor coupling lock) | 10 | Assembly funnel | N69/6 | Right sliding door control unit |
| Remove/install | ||
1 | Remove bottom door trim | ||
2 | Loosen cable ties (12) | ||
3 | Remove electrical connector (11) from right sliding door control unit(N69/6) and electrical connector (13) from wiring harness | ||
4 | Loosen bolt nipple (2) | Installation: Adjust cable with adjustment screw (4) so that a play of approx. 2-3 mm is present between the screw nipple (2) and slider (3). Counter adjustment screw (4) with nut (6). | |
5 | Remove cable (5) from adjustment screw (4) | ||
6 | Remove screw/bolts (7) | ||
7 | Remove right sliding door drive (M73/1) | For this purpose press shaft retainers (8) toward outside in direction of arrows and simultaneously remove electric sliding door drive (M73/1) from shaft (9). | |
Installation: Install shaft (9) in assembly funnel (10) of right sliding door drive (M73/1). Press on drive until shaft retainers (8) arrest. | |||
8 | Remove cable (5) from right sliding door drive (M73/1) | When replacing cable (5) or right sliding door drive (M73/1) | |
9 | Install in the reverse order | ||
10 | Adjust electric sliding door | Completely close sliding door once with switch pressed on center console or door entrance. Then completely open and close sliding door once by momentarily pressing one of the switches. | |
| Check | ||
11 | Check sliding door for proper function |