The superordinate service document as well as the safety information in the service document must be observed.
The next steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
To perform the operation steps, the following commercially available tools are required: rotary wire brush, collet (standard), multifunction unit (spot welding), MIG-MAG inert gas welder (steel, solders, aluminum), wet/dry vacuum cleaner.
1 | Install side roof paneling, fit and fix in place. |
W65.10-1050-01
W65.10-1047-09
2 | Side roof paneling . |
3 | Drill hole for MAG welding and countersink it on one side (area C). |
4 | Side roof paneling (areas A, B, C, D, E, F, G, H). |
Weld side roof paneling from the countersunk side (area C). |
5 | Align the bow on the side roof paneling and weld it . |
6 | Side roof paneling (areas J, K). |
7 | Surface-grind inert gas spot welds (areas A, B, C, D, E, F, G, H, J, K). |
8 | Clean weld joints. |
9 | Remove shavings and drill chips. |
W65.10-1061-01