AR55.10-G-3000A | Remove/install intermediate bearing | 15.6.09 |
MODEL 427.10# ## as of 187036
with CODE (N32) Rear power take-off shaft 1 3/8" spline
with CODE (N37) Rear power take-off shaft 1 3/4" spline
G55.10-3103-09
1 Rear power take-off bearing
2 Anti-fouling protective cover
3 Intermediate bearing
4 Bracket
5 Screw
6 Nut
7 Screw
8 Screw
9 Screw
10 Screw
11 Screw
12 Nut
13 Cable tie
14 Propeller shaft
15 PTO transmission
16 Bellows
| Remove/install | ||
1 | Remove rear power take-off bearing (1) | ||
2 | Unscrew screw (5) and nut (6) from bracket (4) | | |
3 | Unscrew screws (8) on holder (4) | | |
4 | Unscrew screws (9, 10) at anti-fouling protective cover (2) | ||
5 | Remove anti-fouling protective cover (2) | ||
6 | Screw in screw (10) at transmission again. | To prevent soiling or damage of transmission. When replacing the screw, pay attention to the correct screw length so it does not project into the transmission. | |
7 | Detach boot (16) from transmission output | ||
8 | Unscrew screws (7) on holder (4) | | |
9 | Remove bracket (4) | ||
10 | Unscrew screws (11) and nut (12) from intermediate bearing (3) | | |
11 | Detach intermediate bearing (3) with propeller shaft (14) from transmission | Remove to the rear | |
Installation: Coat power take-off shaft profile with long-life grease. | |||
12 | Install in the reverse order |
Power take-off shaft intermediate bearing
Number | Designation | Model 427.102/ | |
BA55.10-N-1001-03A | Screw, power take off shaft intermediate bearing to holder | Nm | 150 |
BA55.10-N-1002-03A | Screw, power take off shaft intermediate bearing cap to holder | Nm | 150 |
BA55.10-N-1003-03A | Screw, holder to frame | Nm | 50 |
Repair materials
Number | Designation | Order number |
BR00.45-Z-1001-06A | Long-life grease | A 000 989 63 51 11 |