W49.10-1134-09
1 | Heat shield | 4 | Nozzle unit | 7 | Clip | ||
2 | Bracket | 5 | Exhaust pipe | 8 | Clip | ||
3 | Coolant lines | 6 | Bracket | 9 | Turbine wheel housing |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on self-locking nuts and bolts | ||
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Disconnect ground line of battery | See information from body manufacturer. | |
2 | Remove air intake hose at ATL | Clamp, air intake hose to turbocharger | |
3 | Remove heat shield (1) | Screw/bolt, heat shield to exhaust gas turbocharger | |
Screw/bolt, heat shield to turbine wheel/transmission housing | |||
4 | Remove bracket (2) of coolant lines (3) | Only for engine version Euro VI Standard | |
5 | Remove nozzle unit (4) on exhaust pipe (5) | Only for engine version Euro VI Standard | |
Do not disconnect coolant lines (3) and fuel line on the nozzle unit (4). | |||
Bolt, housing upper section to housing lower section for nozzle unit | |||
6 | Remove bracket (6) at exhaust pipe (5) and release at timing case | Bolt, bracket to exhaust pipe | |
Bolt, exhaust pipe bracket to timing case | |||
7 | Remove clamp (7) | Installation: Replace clamp (7) and sealing ring on exhaust pipe (5). | |
Bolt, exhaust flex pipe clamp to exhaust pipe | |||
8 | Remove clamp (8) | Installation: Replace clamp (8). | |
Screw/bolt, exhaust flex pipe clamp to exhaust pipe downstream of turbine wheel housing | |||
9 | Remove exhaust pipe (5) | ||
10 | Clean sealing surfaces on exhaust pipe (5) and turbine wheel housing (9) | ||
11 | Install in the reverse order | ||
12 | Start engine and perform an engine test run | Allow engine to run at a higher rotational speed. | |
13 | Check area of exhaust pipe (5) for leaktightness and switch off engine | Visual inspection. |
参照文書
- ah0000n000101a セルフロッキング·ナットおよびボルトに関する注意事項
- ah0000n500001h 汚れおよび異物による損傷防止に関する注意事項
- as0000z000201a 高温になっているか、あるいは赤熱している部品を取り扱う場合に、火傷を負うあるいは失明する危険があります。
- as0000z000501a エンジン作動中に車両がひとりでに動き出す危険があります。 スタート時または作動中のエンジンに接触すると、巻き込まれて負傷をする、または火傷をする危険があります。